Fashion Blogs

Replacing the bathtub in a bathroom with a shower tray is something that, for convenience, has become one of the most frequent small reforms in homes. There is also the case of owners who want to replace the old plate with a new, more modern one and one of the many materials that have been on the market for a few years. In any case, it is very useful to know what mistakes we must avoid at all costs when placing a shower tray in our bathroom . We hope that these 5, which are among the most common, will save you time and possible post-installation troubles.You will need a shower pan.So you can the best shower pan reviews.

 Forgetting to clean PVC parts

Once the area in which the old bathtub was placed has been cleaned, we will have a point on the floor where the floor drain point is located. This is attached to the valve of the new plate by a tube, which is often flexible. In addition to respecting the drop slope to facilitate the lowering of the water, we must clean both areas, the drain point and the valve, with a special cleaning product for PVC pipes. It is also recommended to use a specific adhesive for this type of thermoplastic.

 Not ensuring that there are no water leaks

It does not fit within the normal range, but it is possible that a loss of water will occur when the liquid enters the symphonic boat if it has gaps or a break has occurred. When you go to install it and connect it to the floor drain, check that this is not the case by introducing water into it.

 Use a little or too thick layer of sand

The layer of sand on which we will place the cement, and later the shower tray itself, must have a thickness of       about 25 millimeters . Remember that, before spreading it with the trowel evenly, it is essential to protect the       drain to prevent sand from penetrating into it. To do this, simply cover it with a plastic bag.Do not seat the

shower tray stably

Once the sand and cement have been scattered and placed on the surface that will serve as a seat for the shower tray, it is time to place the shower tray. Before wetting the cement or the polyurethane putty adhesive, check that it is stable and use a level to check it, if necessary. Without actually pasting it, you can place it once, seat it and remove it; The bottom of the plate will give you a good clue as to where you should pour more cement. Then check that the plate angles are well plumb.

 Do not seal the joint between the plate and the ground

In the case of placing a shower tray at ground level, it is especially important to seal the area between the tray and the rest of the floor . Silicone can be used for this. This type of shower is very aesthetic and is installed more and more, but if this aspect is not taken into account, there is a risk of leaks and humidity that can damage the materials and cause serious discomfort.