Fashion Industry Forum

Add ribbons and pine cone on the chairs of a wedding can add a natural treat for the festival. Decorate the chairs of your wedding with pine cones and ribbons to bring the joy of the Dionysian style for your special day wedding dress(http://www.weddingdresstrend.com/en/wedding-dresses ) . While pine cones are most often used as a Christmas decoration in modern homes, this need not be a single use.

Instructions

1.Meça the circumference of the upper part of the backrest, which should be in the form of a grid, with a tape. Cut a piece of tape 9 cm wide in the same length of the circumference of the backrest, over 30 cm.

2.Corte a short form of "V" on the tape ends to stick with a forked look. Place the tape on top of the back of the grid with the ends hanging freely toward the ground. One end of the tape should be 5 cm less than the other.

3. Place a dot of hot glue between the two pieces of tape directly below the top of the chair grid, and press the two layers together wedding dress belts(http://www.weddingdresstrend.com/en/belts ) . This will ensure the ribbon on the chair.

4.Corte a piece of 20 cm floral wire with the wire cutter. Put it on the tape one centimeter below the top of the upper grid, from the back of the chair. Wrap it tightly twice around the tape. Let the end of the intact floral wire.

5.Corte a piece of 60 cm, 9 cm wide ribbon. Tie the ribbon in a simple loop. Adjust the turns of the loop until the ribbon ends have only 2.5 cm long in each side.

6.Set the loop vertically with the center on the wire portion attached to the tape of the chair. Wrap and twist the wire holding the tie ribbon in the center of the loop. Let the ends of the wire intact.

7.Put a pine cone on top of the loop. Attach the top of the cone and the widest part at the center of the loop. Wrap the wire around the cone, using the pinecone scales to hide the wire and attach it to the loop. Trim the ends of the wire.

8.Corte a piece of double-sided tape 15 cm long by 1.5 cm wide. Tie the ribbon around the wireframe area of ​​lace and wide ribbon. Trim the ends and flush. Cut another piece of 25 cm double-sided tape of 1.5 cm width http://www.weddingdresstrend.com/en/unique-a-line-strapless-chapel-train-chiffon-simple-wedding-dress-FHCWA00101.html . Make a loop and cut the ends hanging on a diagonal. Paste the lace center in the top of the pinecone.

9.Dobre metallic pipe cleaner in the form of a flower or a leaf. Paste form the loop of tape 1.5 cm wide.